FS JP Sauer and Sohn drilling in 7x65R and 16 gauge. This is a prewar drilling that has the slimmer fore end and the separate extractors. Engraving is limited to a little scroll. Barrels are 27" I had the gun gone over at Champlin Arms, had the shotgun chambers extended to 2 3/4, fitted to take an Einstecklauf in the right barrel, and a set of pivot mounts installed to take a VariX3 scope I had on hand. The rifle barrel has been shortened by about 3/8 inch by a previous owner, but work was professionally done. Gun is tight and on face and in good working order. I've hunted this gun the last couple years, but the length of pull at 14.5" to the set trigger (13 3/8 to the rear) is a bit long for me. Just selling a few of my guns as I get older and have less opportunity to hunt. I'd like a million bucks would settle for $2950 for the rifle and rings without the scope plus shipping.
If you are interested and would like more info of pictures, Email me at arbegastd at aol.com, where at is replaced by @.
I've been a member for a while, but since I've never posted here before, I can provide references.
Thanks
Dan
If you are interested and would like more info of pictures, Email me at arbegastd at aol.com, where at is replaced by @.
I've been a member for a while, but since I've never posted here before, I can provide references.
Thanks
Dan
Comment