If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have not been able to find how the factory typically regulates the rifle and shotgun barrels in a drilling. Does anyone have knowledge as to the ranges and relationships between the barrels.
Doug,
Conventional drillings are usually regulated a whatever range the maker has avaliable, usually around 80m; but could be 70-100m.The barrels would be soldered together with the convergence and spacing of the muzzles set by experience. The sights would set the point of impact, since only one rifle barrel is involved. Double rifle drillings, Bockdrillings,Vierlings, and Bergstuzens(?) are much more complicated, since more and differing caliber barrels are involved.
Waidmannsheil,
Mike
Comment